Elcometer CG60DL - Page 26

24
en
8.1.1 To switch scan mode on/off
Selection of scan mode is now complete.
8.2 ALARM
The Alarm feature of the Model CG60 and CG60DL allows the user to set an audible and visual alarm when
taking measurements.
If the alarm is switched on, the green light on the front panel of the gauge is illuminated. If the measurement
falls below the value set by the user, a red light shows on the front panel of the gauge and the beeper is
sounded if it is switched on.
Use of the red light and beeper improves the speed and efficiency of the inspection process by eliminating
constant viewing of the reading displayed.
1. Press ON/OFF key to switch on the gauge.
2. Press UP/SCAN key to toggle the status of the
Scan mode. The gauge will display SCAn OFF
or SCAn On depending on which mode the
gauge is in.
3. Repeat step 2 to switch scan mode on or off.
1. Press ON/OFF key to switch on the gauge.
2. Press MODE key to activate features and
settings.
3. Press UP and DOWN arrow keys to scroll to
SCAn symbol. The gauge will display SCAn
OFF or SCAn On depending on which mode
the gauge is in.
4. Press SEND key to switch scan mode on or off.
5. Press MODE key when finished.
Elcometer CG60 Elcometer CG60DL
CG60_CG60DL_TMA_0498_00_01_23225_A6L.fm Page 24 Tuesday, November 22, 2011 12:19 PM