Electro-Harmonix 1440 - Tempo Knob Precision; MIDI Receive Channel

TM.KN – Tempo Knob Fine/Course Mode
This mode allows you to change the TEMPO knob’s precision. Press the MODE
“TM.KN”.
The following are the two modes available for the TEMPO knob:
COAR Coarse mode. The TEMPO knob changes loop speed in 1/2 step interval

FINE Fine mode (factory default). The TEMPO knob increments in 1 BPM steps,

Note: When EXT CLK is enabled, the TEMPO knob is deactivated. A loop’s de-
fault speed is 120 BPM, the TEMPO knob’s 12 o’clock position.
MIDI – MIDI Receive Channel Mode

This mode allows you to set the MIDI receive channel for MIDI Program
Change (PC) and Control Change (CC) messages.
MD.OF disables MIDI receive. MIDI PC and CC messages are ignored.
MD.01 - MD.16 sets the MIDI receive channel to 1 through 16. By default, the
1440 is set to channel 1.
MD.OM enables omni mode where the 1440 accepts MIDI messages on all 16
channels.
For a complete list of MIDI mappings for PC and CC messages see page 16.
- 12 -