Reference Guide and Special Features
1 Shot Mode
t In 1 SHOT Mode, playback stop when the end of the loop is reached.
t If the 1 SHOT button is turned on during loop playback, the 1440 stops play-
back when the loop reaches its end (this can be used to “queue up” a loop
ending even if looping has already been going for a long time). If the 1 SHOT
button is turned off during loop playback the 1440 will continue looping as
normal, cycling to the start of the loop when the end of the loop is reached.
t Overdubbing can be done at any time during loop playback in 1 SHOT Mode.
Overdubbing will automatically stop at the end of the loop.
t If an initial loop recording is made while the 1 SHOT button is lit, the loop
will play back once after the original recording, and then stop.
Looping Function Order: REC/PLAY/DUB or REC/DUB/PLAY
Upon closing a new loop recording, the 1440 can either go directly into Play
mode or Overdub. Changing between the two modes requires power cycling
the 1440, here’s how to toggle between the loop order modes:
1. Pull the power plug or cut power to the 1440.
2. Press and hold the REVERSE button.
4. Continue to hold down REVERSE until you see either the REC or PLAY LEDs
blink. Now release REVERSE.
Set to REC/PLAY/OVERDUB
then the PLAY LED blinks twice. This is the factory default setting.
Set to REC/OVERDUB/PLAY: Upon power-up, both the REC and PLAY LEDs blink
three times simultaneously.
Retrigger
With the RETRIGGER function, each press of the STOP [FX] footswitch immedi-
ately starts the loop over from its beginning. The STOP [FX] footswitch must be
assigned to TRIG to initiate the RETRIGGER.
1. Select SWFX by pressing and then turning the MODE knob.
2. Press MODE then turn the MODE knob to TRIG.
4. To stop a loop, you must double-tap the LOOP footswitch.
4. To erase a loop, press and hold the STOP [FX] footswitch until the MEM LED
blinks. Note: The loop will begin playback prior to initiating the erase function.
Note: Retrigger can only be performed while the 1440 is playing or stopped.
You cannot initiate retrigger during record or overdub.
To Next Page
Loading...
