10
SECONDARY KNOB FUNCTIONS BY DELAY MODE
ECHO – No secondary knob functions.
MOD – The DELAY knob controls modulation rate. Factory default is
0.15Hz, at the 8 o’clock position of the knob. This can be adjusted from
0.01Hz to 328Hz. The FEEDBACK knob controls modulation depth. Default
is at the 12 o’clock position of the knob.
MULTI – The DELAY knob controls volume decay/swell. Factory default is
at 12 o’clock, with no decay or swell. As the knob is turned up, the first
delayed echoes will become quieter. At maximum position, the echoes will
increase in volume from silence. As the knob is turned down, the last
delayed echoes will become quieter. At minimum position, the echoes will
decay to silence, which will sound identical to ECHO mode.
REVRS – The DELAY knob controls pluck sensitivity. Turn the knob up to
make the CANYON more sensitive to your pluck attack, turn it down to
reduce sensitivity. Factory default is maximum sensitivity with the knob
fully clockwise.
DMM – The CANYON can emulate the lush analog modulation of the EHX
Deluxe Memory Man. It is disabled as a factory default, but can be turned
on using the FEEDBACK knob in secondary knob mode. FEEDBACK
controls modulation depth, and factory default is zero, with the knob fully
counterclockwise. Turn the knob up to increase modulation. The DELAY
knob controls modulation rate. Factory default is 0.75Hz, at the 10 o’clock
position of the knob, which corresponds to the Deluxe Memory Man’s
Chorus setting. Set this knob to the noon position to reach the DMM’s
Vibrato setting.
TAPE – The DELAY knob controls the amount of tape distortion, emulating
an aging tape. Factory default is 10 o’clock. The FEEDBACK knob controls
Tape Flutter modulation depth. Factory default is 9 o’clock. Turn both
knobs to the minimum position for a clean, fresh tape tone.
VERB – The DELAY knob controls the reverb time. Factory default is 11
o’clock. Turn this knob up for longer reverb tails, turn it down for shorter.
The FEEDBACK knob controls a low pass filter on the reverb. Factory
default is set to maximum. Turn this knob down to get a darker reverb
sound.
To Next Page
Loading...
