Electro-Voice EVOLVE - Page 16

16 en | Amplifier DSP EVOLVE Portable Column Loudspeaker
2019-08 | 01 | Installation manual Electro-Voice
connection to a high impedance instrument output via a TS plug. Stereo INPUT 5/6 for
connection of stereo line level signals. Connection is made using either two XLR-type,
RCA, or a single 1/8th inch stereo connector. Input 7/8 is reserved for stereo Bluetooth
audio connection.
4. INPUT Selection Buttons - Selects channels INPUT 1 through INPUT 7/8 for channel DSP
settings and individual level settings.
5. MIX OUT - The post-fader audio signals of INPUT 1 through INPUT 7/8are mixed and
passed to MIX OUT. The ratio of the input signals changes when the level controls INPUT
1 - 7/8 are adjusted. This feature allows the loudspeaker to act as a basic eight-channel
mixer that can send the mix to another loudspeaker via the MIX OUT socket.
6. FOOT SWITCH - ON/OFF control of DSP user selectable audio FX.
7. AUX OUT - Auxiliary audio output channel. A separate audio mix of INPUT1 - 7/8 is
controlled by individual channel AUX levels adjustable in DSP.
EVOLVE 50
FUSE T5AL/250V
REPLACE AS M ARKED
OPERATING VO LTAGE / TEGANGAN:
100-240V AC / 50-60 Hz
MAINS I N
POWER
ON OFF
BOSCH SICHERHEITSSYSTEME G MBH
85626 GRASBRUNN, GE RMANY
BOSCH SECURITY SYSTEMS, INC
14450 FAIRPORT, NY, USA
FOR INDONESIA ONLY:
IMPORTED BY / DIIMPOR OLEH
PT ROBERT BOSCH
JAKARTA, INDONESIA
www.electrovoice.com | MADE IN CHINA
10
11
Notice!
Markings and statements on amplifier panel may vary.
8. MAINS IN – The device receives its power supply via the MAINS IN socket. Only the
provided power cord may be used. Connect the device only to a mains network, which
corresponds to the requirements indicated on the type plate.
9. POWER – AC switch for switching the power ON or OFF. The LCD screen lights up when
the power is turned ON, after approximately 3 seconds.