Electro-Voice ZLX-15P User Manual (English)

Other manuals for Electro-Voice ZLX-15P

Owner's Manual22 pages

Quick Start Guide2 pages

Questions and Answers:

S
shillSep 9, 2025
Why is there no streaming audio from my Electro-Voice Speakers?
- C
  chuertaSep 9, 2025
  If you're experiencing no streaming audio with your Electro-Voice speakers, consider the following: * **STREAMING is OFF:** Set STREAMING to PAIRING and initiate the Bluetooth pairing process on your mobile device. * **Mobile device paired incorrectly:** If previously paired to a different Bluetooth enabled ZLX loudspeaker, you may be pairing with the wrong device. Try deleting all saved connections labeled EV ZLX BT and try the pairing process again. * **Input level too low:** While music is playing, turn up the volume on the paired mobile device. You will see the BT VU Meter receiving signal. Reduce if you see a CLIP notification. * **Output Gain is too low:** Increase output gain by setting your LEVEL with the MASTER VOL knob, paying attention to CLIP and LIMIT notifications.
M
Michelle SosaSep 12, 2025
Why is there no sound with a microphone connected to Electro-Voice ZLX-15P Speakers?
- A
  Ariana GomezSep 12, 2025
  If no sound is produced when a microphone is connected to INPUT 1 or INPUT 2 on your Electro-Voice speakers, there are a couple of possibilities: * **Phantom power:** Use a dynamic microphone that does not require phantom power. If using a microphone requiring phantom power, an external phantom power source is needed. * **Input gain knob:** Slowly increase the input gain knob level to engage the microphone pre-amp.
F
fryjonathanSep 12, 2025
What causes cracking or distortion in Electro-Voice ZLX-15P output?
- E
  Elizabeth RodriguezSep 12, 2025
  Intermittent output, like cracking or distortion, from Electro-Voice speakers often points to a faulty connection. Check all connections at the amplifier and loudspeakers to ensure they are clean and tight. If the problem continues, inspect the wiring as described in the troubleshooting for 'no sound'.
R
Richard GonzalezSep 14, 2025
Why does streaming audio skip or stutter on my Electro-Voice ZLX-15P Speakers?
- R
  Rebecca ChurchSep 14, 2025
  Skipping or stuttering playback during streaming audio on your Electro-Voice speakers can be due to: * **Distance:** Move the paired mobile device closer to the loudspeaker. * **Interference:** This Bluetooth enabled loudspeaker occupies the same operating frequencies as other Bluetooth devices, as well as Wi-Fi and other wireless transmissions (like wireless home phones). If you are experiencing drop- outs, your speaker may be in an environment that makes reliable wireless audio difficult. Try to move the loudspeaker to different locations in the room, and especially away from 2.4gHz routers and microphone receivers. If the problem persists, revert back to a wired connection while at that particular venue.

Electro-Voice ZLX-15P Specifications

General

Product color	Black
Volume control	Rotary
Housing material	Polypropylene (PP)
Recommended usage	Studio
Suitable for outdoor use	Yes
Speaker type	2-way
Number of drivers	2
Speaker placement	Floor
Audio output channels	1.0 channels
Woofer diameter (imperial)	12 \
Tweeter diameter (imperial)	1.5 \
Amplifier class	D
Impedance	- Ω
Frequency range	42 - 20000 Hz
RMS rated power	- W
Headphone connectivity	3.5 mm
Connectivity technology	Wired
6.35 mm (1⁄4-inch) input	1
AC input voltage	100 - 240 V
Power source type	AC
Package weight	23000 g