Electro-Voice ZxA1-Sub - Rotating the 90° Horn; Rotating the Logo

Electro-Voice ZxA1 Series Owner’s Manual
9
Rotating the 90° Horn
The 90° version of the ZxA1 allows for the horn to be rotated for more effective coverage if desired. The horn is factory-
installed with the 90° coverage in the horizontal plane and the 50° coverage in the vertical plane. The 100° version of the ZxA1
has the same coverage pattern in both the horizontal and vertical planes, so rotating the horn will not change the coverage
pattern.
To rotate the horn follow the steps below:
1. Remove the grille screws/grille assembly.
2. Remove the horn screws/horn assembly.
3. Rotate the horn assembly 90°.
4. Secure the horn assembly with the horn mounting screws.
5. Secure the grille assembly with the grille mounting screws.
90° x 50° Horn
Rotating the Logo
All versions of the ZxA1 (except the ZxA1-Sub) allow for the logo badge to be rotated,
if desired. The logo badge is square and can be rotated in 90° increments.
To rotate the logo badge, follow the steps below:
1. Using a finger or flat-edge screwdriver (using care not to scratch grille),
grip under the logo badge.
2. Pull the logo badge outwards from the logo recess until it fully clears the front
surface of the grille.
3. Rotate the logo badge, in 90° increments, to the desired orientation.
4. Release the logo badge and let it “spring” back into the logo recess.
Figure 5:
Rotating the ZxA1-90 Horn
Figure 6:
Rotating the ZxA1 Logo
Horn Mount
Screws
Grille Mount
Screws
Grille
Assembly
Enclosure
90° x 50°
Horn