8
Convection roast 65
To set the convection roast feature 65
Self-clean cycle 65
To set the controls for the self-cleaning cycle to
start immediately and shut off automatically 65
When the self-clean cycle is completed 66
Stopping or interrupting a self-cleaning cycle 66
How the ES 400 control system works 66
Preheat 66
Bake 66
Time bake 66
Convection bake 66
Convection roast 67
Broil 67
Clean 67
Calibration 67
To check oven calibration 67
To change the calibration 67
To adjust the oven temperature higher 67
To adjust the oven temperature lower 67
Troubleshooting 67
F1 code 67
F3 code 67
F9 code 68
Control will not program 68
Time bake does not operate 68
Convection bake and convection roast 68
Neither the fan motor or the assist element operates 68
If either convection bake or convection roast
operate normally but the other does not 68
Fan motor does not operate 68
Convection element does not operate 68
Control does not operate in preheat 68
Blank display 68
Bake element does not heat 68
Broil element does not heat 69
Oven door does not lock when the
oven is programmed for clean 69
Oven door locks but the oven does not heat 69
Door latch is partly closed with door open 69
Sample schematic for ES 400 control system 70
The ES 450 Electronic Oven Control System 71 - 80
How to program the ES 450 71
Clock 71
To set the clock 71
Changing between 12 or 24 hour time of day display 71
Continuous bake or 12 hour energy saving 71
To set the control for continuous bake
or 12 hour energy saving 71
Minute timer 72
To set the minute timer 72
To change the minute timer while it is in use 72
To cancel the minute timer before the
set time has run out 72
Oven lockout feature 72
To activate the oven lockout 72
To reactivate oven operation 72
To Next Page
