Electrolux 30" - Sample Schematic for PRC Glass Touch Control System

140 pages

To Next Page

To Previous Page

GND

Sample schematic for PRC Glass touch control system

Main Page

Safe Servicing Practices2
Table of Contents3
Quick Reference Sheet15
Maximum Allowable Surface Temperatures16
Sectiona - 30" Electric Freestanding Installation Instructions17
Serial Plate Information18
Grounding Instructions19
Leveling the Range20
Drill Pilot Holes and Fasten Bracket21
Section a - 40" Electric Freestanding Installation Instructions22
Important Notes to the Installer23
For Models with Self-Clean Feature24
Three Conductor Wire Connection to Range25
Direct Electrical Connection to the Circuit26
Junction Box Location27
Preparation28
When All Hookups Are Complete29
Section B - Accessories31
Troubleshooting32
Element Does Not Cycle33
Both Elements Do Not Heat34
Top Element Electronic Control System35
How It Operates36
F6 Code:37
Blank Display38
Element Does Not Cycle39
How to Program the es 10040
To Broil41
Calibration42
Normally, the Broil Element Heats but the Bake Element Does Not Heat43
Sample Schematic for es 100 Control System44
The es 200 Electronic Oven Control System45
To Change the Oven Temperature after Baking Has Started46
To Set the Controls for a Self-Clean Cycle47
Broil48
F9 Code:49
Lock Motor Runs Continuously50
The es 300 Electronic Oven Control System52
To Change the Minute Timer While It Is in Use53
To Program Oven for a Delayed Start Time and to Shut-Off Automatically54
To Broil55
To Set the Controls for a Self-Clean Cycle56
Time Bake57
The Broil Element Does Not Heat58
Oven Door Locks When the Oven Is Programmed for Clean but the Oven Does Not Heat59
The es 400 Electronic Oven Control System61
To Cancel the Minute Timer before the Set Time Has Run out62
Preheat63
To Broil64
Convection Bake65
When the Self-Clean Cycle Is Completed66
Convection Roast67
F9 Code:68
Broil Element Does Not Heat69
The es 450 Electronic Oven Control System71
Minute Timer72
Immediately and to Shut off Automatically73
To Program the Oven for a Delayed Start Time and to Shutoff Automatically74
Convection Bake75
When the Self-Clean Cycle Is Completed76
Convection Bake77
To Adjust the Oven Temperature Lower78
Convection Element Does Not Operate79
The PRC Glass Touch Electronic Oven Control Models81
Electronic Oven Control82
Timer Reminder83
To Cancel the Minute Timer before the Set Time Has Run out84
Bake85
Broil87
Convection Bake88
Convection Roast89
Timed Bake90
Delayed Timed Bake91
To Set the Controls for the Self-Cleaning Cycle to Start Immediately and Shut off Automatically92
To Start the Delayed Self-Clean Cycle93
Adjusting Oven Temperature94
Capacitance Touch Glass95
F9 Code:96
Oven Door Does Not Lock When the Oven Is Programmed for Clean97
Sample Schematic for PRC Glass Touch Control System98
Troubleshooting99
If the Element Does Not Cycle off100
Top Trim on Backguard Area101
Removing the Oven Light or Fluorescent Switch102
Removing Electronic Oven Control103
Removing the Large Element Safety Thermostat104
Removing Indicator Lights105
Removing the End Caps106
Terminal Block107
Removing the Main Top (Smooth Top Models)108
Removing the Burner Pan (Coil Models)109
Removing the Oven Door110
Removing the Inner Door Heat Shield111
Inside the Oven112
Removing the Oven Vent (Coil Top Models and Bottom Part of the Vent System on Smooth Top Models)113
Removing the Oven Light Socket114
Removing the Drawer Glide115
Removing Side Rail on from the Drawer116
Removing the Warmer Drawer Diode117
Removing the Top of the Warmer Drawer Cavity118
Removing the Leveling Leg and Roller Assembly119
Removing Small Panel120
Removing the Lock Motor Assembly121
Removing the Door Switch122
Section E - 40" Disassembly and Replacement of Parts123
Removing the Thermostat and Top Element Knobs124
Removing Indicator Lights125
Removing the Control Panel126
Removing Rear Hinge127
Removing the Front Oven Trim128
Removing the Large Oven Door Outer Panel129
Removing the Wool Shield130
Removing the Seal between the Inner Glass and the Inner Door Liner in the Large Oven Door131
Removing Large Oven Bake Element132
Removing the Large Oven Vent133
Removing the Small Oven Broil Element134
Removing the Drawer Glide135
Bodyside136
Removing the Side Heat Shield137
Removing the Large Door Righthand Hinge Roller Bracket138

Electrolux 30" - Sample Schematic for PRC Glass Touch Control System

Table of Contents

Other manuals for Electrolux 30"

Related product manuals