Electrolux 7000 - Component Removal and Replacement

70
Removing the front panel:
1. Disconnect the dryer from electrical supply and
remove the console.
2. Remove the (2) screws, one on each side, at the
bottom holding the front panel to the bodysides.
3. Raisethefrontofthedryer andremove the (2)screws
holding the bottom of front panel to the dryer base.
2. Use a pair of pliers and push the catch forward until
the two metal prongs on the catch hits the catch
plate.
3. Using a small screwdriver, push down on the metal
prongs to release to catch out the front.
Removing the door switch:
1. Disconnect the dryer from electrical supply, open
the door and remove the top.
2. Disconnect the wires from the door switch.
3. Squeeze the release tabs on the ends of the switch
and push it out the front.