Page 29
COOKTOP & ELEMENTS
The procedure for servicing the smooth glass cooktop
and surface elements is similar to other Electrolux
manufactured ranges. The front of the cooktop can
be lifted by removing the screws that secure it to the
range chassis. (Photo A)
Once these screws have been removed slide the
entire cooktop assembly forward approximately three
inches to disengage the hinge tabs found on each
side of the cooktop from the slot in the backguard
assembly. (Photo B).
Raise the front of the top up and use a wooden
or plastic dowel to support the top while service is
performed. (Photo C)
With the cooktop in the raised position the surface
heating elements, warmer zone element and their
wiring connections are accessible.
COMPONENT ACCESS AND REPLACEMENT
Remove Screws
Photo A
Hinge Tab
Tab Slot
Photo B
Photo C
To Next Page
Loading...
