Page 45
The warmer drawer element and thermo disc are
mounted to a metal base pan which must be removed in
order to replace the element.
Remove the lower wire shield from rear of the range.
Unplug the warmer drawer harness connector and push
the connector through the slot in the back panel so that it
can be removed with the element and base assembly.
Remove the screws that secure the warmer drawer base
and the warmer drawer side shields to the main back
panel. (Photo A)
Side Shield Screws
Harness Connector Plug
Remove the ¼” hex screws that secure the drawer
guide rail and element base pan on each side of the
drawer opening. (Photo B)
Remove the drawer guide rail and drawer shield together
by pulling straight forward.
Once both of the drawer guide rails and side shields have
been removed the base pan and element assembly can
be pulled forward to remove from the range. (Photo C)
→→
Pull base pan forward to
remove
Base Pan Screw
Guide Rail Screw
Drawer Side Shield
Drawer Guide Rail
Element Base Pan Screw
Photo A
Photo B
Photo C
With the element and base pan assembly removed
the element and thermo disc are accessible for
servicing. (Photo D)
To remove the element from the pan remove the
screws and clips that secure it to the pan. Also remove
the screw that secures the thermo disc mounting
bracket.
When reinstalling the thermo disc mounting
shield is installed and properly positioned.
Warmer Drawer Element and
Base Pan Assy
Thermo Disc Mounting Bracket
Terminal Shield
Photo D
Mounting Screws and Clips
To Next Page
Loading...
