Page 30
3. Before the element can
be removed from the support
channel the locking tab on the
mounting clip must be closed
by squeezing shut with a pair
of pliers. After the repair is
complete the tab can be
reopened by using an awl or
similar instrument.
4. Remove the mounting screw that secures the
element support channel to the cooktop.
5. Carefully pull the support channel away from
the cooktop far enough to disengage the element
mounting clips from the channel. Slide the element
out from between the support channel and the
cooktop. Reinstall or replace the element by
reversing steps 1-5.
The element mounting clips must be removed
from the original element and mounted to the
body are numbered to identify the clip mounting
locations.
Clip
Surface Element Replacement
1. Before removing the element be sure to note
the locations of the element mounting clips in the
support channel slot. The replacement element must
be installed in the same position.
2. Carefully remove the wires from the element.
Take note of the terminal identication on the
element terminal block for each wire connection.
To Next Page
Loading...
