Page 32
To service or replace the door components remove
the door as previously described and place the door
on a protected work surface with the handle side
down.
Photo A
REMOVE
SCREWS
Begin disassembly by removing the two screws
at the top of the porcelain door liner (Photo A),
Carefully turn the door over so that the handle side
is facing up. Remove the four screws located along
the bottom edge of the door. (Photo B )
Lift off the outer glass panel with door handle and
top trim cap attached.
Photo B
REMOVE
SCREWS
Door Disassembly
To remove and replace the door handle or top trim
cap remove the two screws on the back side of the
trim cap that secure the cap and door handle to the
door panel outer glass . (Photo C)
Photo C
REMOVE SCREWS
Photo D
FOIL TAPE
The outer door panel is replaced as an assembly
which includes the metal frame with outer glass, foil
tape and name badge already attached.
If the foil tape is not already attached install it
around the window opening as seen in Photo D.
To Next Page
Loading...
