Electrolux EOB944 - Choice of Electrical Connections

Choice of electrical connections
There are two possible ways to connect your cooker,
please choose from the most appropriate after reading
the descriptions:
• It is recommended that this appliance is wired
with suitably rated cable (min 13 A), into fixed
wiring using a double pole isolator with at least 3
mm contact separation in ail poles and neutral,
located within 2 m of the appliance. If this fixed
wiring circuit is only supplying the cooker, then a
fuse of 13 A (or circuit breaker) should be incor¬
porated. When the circuit combines oven and
hob, then wire and fuse rating should be increa¬
sed accordingly.
Subject to Regional Electricity Company
regulations if you wish to connect the oven
and hob to the power supply you may use
one of the following methods :
• If you wish to connect an oven and a hob to a
cooker point you can :
- by connecting the oven and hob separately
to the cooker point. Oven and hob units
should be separately connected to a control
panel. In this case the cooker should be ope¬
rated from 6 mm 2 twin core, and earth, PVC
insulated multicore cable. See Fig. 1.
29