16
PLACEMENT OF BURNER HEADS AND CAPS
LOCATIONS OF THE BURNERS
Place the burner head over the gas orice (Figure 1).
Make sure electrode ts correctly into slot
in burner head.
Place a burner cap on each burner head
(see Figure 2), matching the cap size to
the head size. The cap for each burner
has an inner locating ring which centers
the cap correctly on the burner head. Be
sure that all the burner caps and burner
heads are correctly placed BEFORE using
your appliance.
Make sure each burner cap is properly
aligned and level.
Turn the burner on to determine if it will
light. If the burner does not light, contact a
Service Center. Do not service the sealed
burner yourself.
Burner Cap
Burner
Head
Figure 2
Figure 1
Burner
Head
Gas
Opening
The cooktop is equipped with different sized burners.
The surface burners are located on the cooktop as follows (See
Figure):
- a (natural gas) burner located at the right rear
position;
- a (natural gas) burner located at the right front
position;
- a (natural gas) burner located at the left front position;
- a (natural gas) burner located at the left rear
position.
PROPER BURNER ADJUSTMENTS
The color of the ame is the key to proper burner adjustment. A good ame is clear, blue
and hardly visible in a well-lighted room. Each cone of ame should be steady and sharply
dened. Adjust or clean burner if ame is yellow-orange. To clean burner, see instructions
under General Care & Cleaning.
To Next Page
Loading...
