17
Always use a utensil for its intended purpose. Follow manufacturer’s
instructions. Some utensils were not made to be used in the oven or on the
cooktop.
and straight sides.
• Tight tting lids.
• Weight of handle does not tilt pan.
Pan is well balanced.
• Pan sizes match the amount of
food to be prepared and the size of
burner.
• Made of material that conducts heat
well.
• Easy to clean.
• Curved and warped pan bottoms.
• Pan overhangs unit by more than
2.5 cm (1”).
• Heavy handle tilts pan.
• Flame extends beyond unit.
Pans should have at bottoms.
Check for atness by rotating a
ruler across the bottom. There
should be no gaps between the
pan and ruler.
* Specialty pans such as lobster
pots, griddles and pressure cook-
ers may be used but must con-
form to the above recommended
cookware requirements.
SURFACE COOKING UTENSILS
FLAME SIZE
For most cooking, start on the highest control setting and then turn to a lower one to complete
the process. Use the chart below as a guide for determining proper ame size for various
types of cooking. The size and type of utensil used and the amount of food being cooked will
inuence the setting needed for cooking.
For deep fat frying, use a thermometer and adjust the surface control knob accordingly. If
the fat is too cool, the food will absorb the fat and be greasy. If the fat is too hot, the food will
brown so quickly that the center will be undercooked. Do not attempt to deep fat fry too much
food at once as the food will neither brown nor cook properly.
High Flame Start most foods; bring water to a boil;
pan broiling
Medium Flame Maintain a slow boil; thicken sauces,
gravies; steam
Low Flame Keep foods cooking; poach; stew
Never extend the ame beyond the outer edge of the utensil. A higher ame simply wastes
heat and energy, and increases your risk of being burned by the ame.
To Next Page
Loading...
