46
cautioN
- Use caution when replacing the burner head so the electrode is not damaged. A damaged electrode
may cause a delayed ignition or prevent the burner from igniting
- Any additions, changes or conversions required in order for this appliance to perform satisfactorily
must be made by a qualied service technician.
General Care & Cleaning
CLEANING THE BURNER GRATES, BURNER CAPS AND
BURNER HEADS
THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.
The Grates, Burner Caps and the Large 18k Burner Head
should be routinely cleaned. Keeping the burner ports clean
will prevent improper ignition and an uneven ame. If needed,
the xed burners should be cleaned in place with an humid
cloth (do not spraw water on them).
Refer to the following instructions:
Remove
in the following order; (1st) Surface Burner Grate, (2nd)
Surface Burner Cap, (3rd) Surface Burner Head (See Figure
1).
Reverse the procedure above to replace the Surface Burner
Cap, Surface Burner Head and Surface Burner Grate.
1st
2nd
3rd
Orice
Electrode
Surface Burner
Head
Surface Burner
Cap
Figure 1
Surface Burner
Grate
Use a soap-lled
scouring pad or a mild abrasive cleaner to clean the surface burner caps and surface
burner heads. The Grates are designed to be Dishwasher safe for cleaning. The ports (or
slots) around the burner heads must be routinely cleaned. If residue still remains in these
ports, use a small-gauge wire or needle to clean the slots or holes being careful not to
damage the electrode. For proper ow of gas and ignition of the burner—
make sure that the surface burner cap, the
surface burner head and the surface burner grate are properly in place whenever a surface
burner is in use.
To Next Page
Loading...
