4. InLet Hose ConneCtIon (CONT’D)
4.2 Loading
• Drop items into washer loosely. Items
should move easily through wash
water for best cleaning and wrinkle-free
results.
• Load washer properly and select correct
load size setting. Overloading and
selecting a setting too small for the wash
load can :
• Cause poor cleaning
• Increase wrinkling
• Create excessive lint
• Wear out items faster
(because of pilling)
• Mix large and small items in each load.
Load evenly to maintain washer balance.
An unbalanced load can make the
washer vibrate during spin.
• Reduce wash time when using a small
load size setting. Load with only a few
small items needs less wash time.
• Use a large load size setting to reduce
wrinkling with permanent press clothes
and some synthetic knits.
These items should have more room
to move in the water than heavy items.
(towels, jeans)
4.3 Adding detergent
1. Detergent case (Fig.10) 2. Adding fabric softener
• If desired, add measured liquid fabric
softener to the softener inlet.
• Pour liquid fabric softener into
the dispenser using the amount
recommended on the package.
• Do not exceed the maximum ll line.
Overlling can cause early dispensing
of the fabric softener which could stain
clothes.
• Do not open the detergent case when
water is supplied.
• Avoid pouring fabric softener directly on
the clothes.
Main wash
Fabric
softener
Pre wash
Fig. 10
To Next Page
Loading...
