Electrolux EWW1122DW - Washing Program and Selection; Cottons Program

17
English
7. WAsHInG PRoGRAM AnD seLeCtIon
7. 1 Cottons Program
1
Put the laundry into the Drum and put the detergent and softerner
into the detergentcase. Then close the Door.
• Put the detergent into the main wash room (I I marking) and
prewash room(I marking) in the detergent case.
• Softener should be below ‘MAX’ level.
• Put the detergent into the pre wash room (I marking) only if you
want to add prewash.
• When you want to use bleach, put it into the main wash room
(I I marking) with detergent.
2
Press the Power button.
• The LED shows only ‘- --’ signal.
3
Select the ‘COTTONS’ program using the program selection dial.
• If you press ‘Start/Pause’ button aftrer pressing Power button
without selecting program, the ‘Cotton’ program is selected as
default program.
• ‘Main wash’ and ‘Nomal’ soil level and ‘2’ times rinse and
‘Extra High’ rpm spin speed and ‘40°C’ water temperature are
selected automatically.
• If you want to change the ‘Water Temperature’ and ‘Soil level’
and ‘Washing Course’ and ‘Rinse Time(s)’ and ‘Spin Speed’,
select program what you want to change by pressing each
button.
4
Press the ‘Start/Pause’ button.
• The washer will be operated with locking Door and supplying
water after sensing the amount of laundry automatically.
NOTE
• If you want to change the setting program during operation, press the ‘Start/Pause’
button to hold the operation and change the program you want to change by pressing
each corresponding button.
• Water temperature ‘95°C’ is not selectable in order to prevent clothes from damaging.
• If you want to add the clothes during operation, press ‘Start/Pause’ button and ‘Unlock
(Add Clothes)’ button, then open the Door and put the clothes into the Drum and then
close Door and press ‘Start/Pause’ button again.