10. HoW to CLeAn tHe FILteR
10.1 Cleaning your washer
Clean the lter when water leaks from the water inlet.
1. Pull the power plug out before cleaning it.
2. Turn off the water supply to
the washer and separate the
inlet hose.
3. Pull the inlet lter out.
1. Open the lower cover (1) by
using a coin. Remove the cap
hose (2) to pull out the hose.
2. Unplug the cap hose (2),
allowing the water to ow out.
At this time use a vessel to
prevent water owing on to the
oor. When water does not ow
any more, turn the pump lter
(3) open to the left.
3. Remove any foreign material
from the pump lter (3). After
cleaning, turn the pump lter
clockwise and insert the cap
hose (2) to the original place.
Close the lower cover.
4. Remove the dirt from the inlet
lter with a brush.
10.2 Cleaning your washer
• This drain lter is used to screen the foreign stuffs such as threads, coins, pins, buttons
etc.
• If the drain lter is not cleaned at proper time(every 10 times of use), drain problem could
be caused.
CAUTION!
Be careful when draining if the water is hot.
2 3 4
1 2
3
2
3
To Next Page
Loading...
