8. GUIDe FoR otHeR UseFUL PRoGRAMs
8.1 Time Delay (Reserved Washing)
1
Put the laundry into the Drum and put the detergent and softerner
into the detergent case. Then close the Door.
• Put the detergent into the main wash room (I I marking) and
prewash room(I marking) in the detergent case.
• Softener should be below ‘MAX’ level.
• Put the detergent into the pre wash room(I marking) only if you
want to add prewash.
• When you want to use bleach, put it into the main wash room
(I I marking) with detergent.
2
Press the Power button.
• The LED shows only ‘- --’ signal.
3
Select the program using the program selection dial.
• If you press ‘Start/Pause’ button aftrer pressing Power button
without selecting program, the ‘Cotton’ program is selected as
default program.
• If you want to change the ‘Water Temperature’ and ‘Soil level’
and ‘Washing Course’ and ‘Rinse Time(s)’ and ‘Spin Speed’,
select program what you want to change by pressing each
button.
4
Press the ‘Time Delay’ button.
• The ‘Time Delay’ LED is to be lighting.
• Select the time delay time you want from 2 hours to 12 hours
by pressing button.
• The displayed time shows program nishing time.
5
Press the ‘Start/Pause’ button.
• If you make this program successfully, only ‘Time Delay’
and ‘Lock’ LED are lighting.
NOTE
• If you want to check the selected program, press the ‘Start/Pause’ button again.
• Preparing washing before starting ‘Delay’;
- Turn on the water tap.
- Load laundry and close Door.
- Place the detergent and fabric softner in the detergent case.
• The actual time of nishing may be slightly different from the displayed time because of
water supply condition or water temperature, etc.
• ‘WOOLLENS’ and ‘DELICATES’ and ‘CLEAN ME’ programs can not be used with
‘Delay’.
• Adding clothes during ‘Delay’ operation is not allowed.
To Next Page
Loading...
