487 05 40 31
4.5
4. Programmes
4
Service
manual
Start
1. Switch the user module to programming mode (See section 3).
2. Move to
Area B (See “To Access Area B” in group 2 ).
3. Step forward using to
7_ _
4. Press
Enter to enter subgroups within main groups 7 01
5. Step forward from 7 01 using to
7 04 and then press Enter
Note! The factory setting is displayed.
6. Press
Enter
Note! The factory setting flashes and is changeable.
7. Step forward using till the setting is reached.
8. Accept the setting using All values are stored when the display stops
flashing.
When the programming has been completed, move the switch back to normal position.
Or if further changes are to be carried out
9. Press
Return to Subgroup 7 04.
10. Press
Return to Main group 7 _ _.
11. Press
Up or Down depending on the Main group number in
which changes are to be carried out.
Changing factory settings
In order to clarify things a step by step instruction of how to move within a main group
follows.
Based on an example the instruction shows how to change the residual moisture factory
setting in program 4 (See Overview of factory setting Group 7).-
To Next Page
