EasyManua.ls Logo

Electrolux TE1120 - Hints and Tips for Use; Ecological Drying Tips; Adjusting Laundry Moisture Degree; Deactivating Reservoir Indicator

Electrolux TE1120
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User manual
17
11 Hints and tips
11.1 Ecological hints
Spin the laundry well before drying.
Do not exceed the load sizes which are specified in the programs chapter.
Clean the filter after each drying cycle.
Do not use fabric softener to wash and then dry. In the tumble dryer laundry becomes soft automatically.
Use the condensate as distilled water, e. g. for steam ironing. If it is necessary clean the condensate before (e.g.
with a coffee filter) to remove possible small pieces of fluff.
Always keep the airflow slots at the bottom of the appliance clear.
Make sure there is good airflow where the appliance is to be installed.
11.2 Adjustment of the remaining laundry moisture degree
To change the default degree of the remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select one of available programs.
4. Push at the same time and hold down the Half load
and Cupboard dry buttons.
One of the symbols goes into the view on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause button again and again until you set necessary degree.
6. To memorise the setting, push at the same time the Half load
and Cupboard dry buttons for approximately
2 seconds.
11.3 Deactivating the Reservoir indicator
The water container indicator is by default on. It starts to light at the end of the drying cycle or during the cycle if the
water reservoir is full. If the draining kit is installed the water container is drained automatically and indicator can be
permanently off.
To deactivate the indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select one of available programmes.
4. Push at the same time and hold down the Half load
and Iron dry buttons.
One of two configurations is possible:
The Reservoir indicator is on and the symbol
goes into the view - the water container indicator is per-
manently on.
The Reservoir indicator is off and the symbol
goes into the view - the water container indicator is per-
manently off.

Related product manuals