Electrolux TE1120 - Emptying the Water Container

User manual
19
fig.X02227
5. If necessary, clean the filter with a vacuum cleaner. Close the filter.
6. If necessary, remove lint from the filter socket and gasket. You can use a vacuum cleaner. Place the filter back in-
side the filter socket.
fig.X02229
12.2 Emptying the water container
Empty the condensed water container after each drying cycle.
If the condensed water container is full, the program stops automatically.
The symbol
Reservoir appears on the display and you must empty the water container.
To empty the water container:
1. Pull the water container out keeping it in a horizontal position.
fig.X02230
2. Pull the plastic connection out and drain the water into a basin or equivalent receptacle.
fig.X02231
3. Push the plastic connection back in and place the water container back into position.
4. To continue the program press the Start/Pause button.