48
Installation manual
Important
Never handling the machine without the transportation bridles.
13Drain connection
The machine's exhaust sleeve outside diameter is of 110 mm (4.33″). It is located underneath the machine.
The waste water collector diameter 200 mm (7.87″) (manufactured by customer) should have a 3 cm/m (3 %) slope
and resist to a temperature of 90 °C (194 °F). It should be connected to the waste water general network in accord-
ance with local codes and regulations.
Adapt and connect the machine's exhaust sleeve to the waste waters' collector (rubber bend and connection nozzle
are supplied in the machine with collars).
Drawing of drain connection to waste waters' collector
1. Connect the hose (B) to the connect nozzle (C).
2. Seal and fix the nozzle (C) using 2 screws.
3. Them connect the hose (B) to the drain's evacuation sleeve (A).
A Drain's evacuation sleeve
B Connection hose
C Connection nozzle
D Waste water collector
To Next Page
Loading...
