50
H5 Residual risks
The machine has several risks that were not com-
pletely eliminated from a design standpoint or with the
installation of adequate protection devices.
Nevertheless, through this manual the Manufacturer
has taken steps to inform operators of such risks, care-
fully indicating the personal protection equipment to be
used by them.
Sufficient spaces are provided for during the machine
installation phases in order to limit these risks.
To preserve these conditions, the corridors and areas
around the machine must always be:
• kept free of obstacles (e.g. ladders, tools, contain-
ers, boxes, etc.);
• clean and dry;
• well lit.
For the Customer’s complete information, the residual
risks remaining on the machine are given below; such
actions are to be considered incorrect and therefore
strictly forbidden.
Table 6 Residual risks
RESIDUAL RISK DESCRIPTION OF HAZARDOUS SITUATION APPLICATION
PHASE
Slipping or falling The operator can slip due to water or dirt on the floor. Normal use
Maintenance
Catching, dragging or
crushing
Catching or dragging of the operator or other persons in the
drive, during the machine work phase, due to improper actions,
such as:
- placing an arm inside the machine to remove a stuck rack
without stopping the machine by operating an emergency
switch;
- accessing the rack handling system without stopping the
machine by operating an emergency switch.
Use of improper clothing with loose parts (e.g. necklaces,
scarves, shawls, ties, etc.) or long hair not gathered, which could
get caught up in moving parts.
Normal use
Maintenance
Cleaning
Burns The operator deliberately or unintentionally touches some com-
ponents inside the machine or dishes at the outfeed without
using gloves or without allowing them to cool.
Normal use
Maintenance
Cleaning
Shearing of upper limbs The operator violently closes the front panels. Normal use
Maintenance
Cleaning
Electrocution Contact with live parts during maintenance operations carried
out with the electrical panel powered. The operator intervenes
(with a power tool or without disconnecting the power to the
machine) lying down on the wet floor.
Maintenance
Falling from above The operator intervenes on the machine using unsuitable sys-
tems to access the upper part (e.g. rung ladders, or climbs on it).
Installation
Normal use
Maintenance
Tipping of loads During maintenance on the machine or the packing containing
the machine with the use of unsuitable accessories or lifting sys-
tems or with load unbalanced.
Installation
Maintenance
Chemical Contact with chemical substances (e.g. detergent, rinse aid,
scale remover, etc.) without taking adequate safety precautions.
Therefore always refer to the safety cards and labels on the prod-
ucts used.
Installation
Normal use
Maintenance
Cleaning
To Next Page