58
I8 Troubleshooting
THE DISHWASHER DOES NOT WASH
PROPERLY
1. Check the suction filter and carefully clean it if
dirty.
2. Make sure the wash jets are not clogged by solid
residuals.
3. Make sure the initial quantity of detergent and/or
subsequent additions are correct.
4. Make sure the modules making up the machine
respect the recommended values given in the
technical data table.
5. Make sure the dishes are correctly placed in the
racks.
GLASSES AND DISHES ARE NOT PROPERLY
DRIED
1. Make sure there is rinse aid in the container and
top-up if necessary.
2. Make sure the water temperature of the rinse
module is between 80°C and 90°C.
3. If present in the machine, check operation of the
drying module (that hot air comes out).
4. Make sure the curtains are correctly positioned.
5. Make sure the dishes were not immersed in
foamy detergent (e.g. hand wash detergent)
before being put in the machine.
CONDENSATE ON GLASSES
1. Make sure there is rinse aid in the container and
top-up if necessary.
STAINS ON GLASSES
1. Only use “non-foaming” products for professional
dishwashers.
EXCESSIVE FOAM IN THE TANK
1. Make sure the washing module water tempera-
ture is not below the minimum recommended
value given in the technical data table.
2. Make sure the tank has been cleaned with suita-
ble detergents.
3. Empty the tank and carefully rinse before resum-
ing work.
4. If a foaming detergent was used, empty and refill
the tank with water until the foam has been
removed.
To Previous Page