Appendix B: Transmitter Installation
iConnect
Installation Manual
119
Deleting the I/O Expander Module
To delete a 2-Way Wireless I/O Expander Module from the system:
1. Set the system to Delete mode.
• Go to the main menu and select [9]>[1]>[6] (Programming > Devices > Zone Expanders).
• Select a 2-Way Wireless I/O Expander Module from the list (1-2) and press '√ʹ.
2. Press >3, and then press '√ʹ. Upon the ‘OK’ confirmation request, press ʹ√ʹ
3. Open the plastic unit (see Figure 5 1 and Figure 6 1) and disconnect the main AC power.
4. Press the tamper switch. While the tamper switch is being pressed connect the power. Within five seconds open the
tamper and close it again.
To Next Page
Loading...
