9 Technical specifications
Size (B x H x T) 80 x 155 x 38 mm
3.7V 4600 mAh Li-Ion battery (internal)
Power consumption when recording
Power consumption in sleep mode
Operating time (recording)
approx. 18 h per battery charge
Operating time (sleep mode)
approx. 400 h per battery charge
Wall power supply 12 VDC (100-240 VAC)
Charging socket (voltage, capacity)
9 V DC to 15 V DC, min. 5 W
I- /U-charge with 750 mA / 4.2 V
approx. 7 h (full charge)
Sampling rate 312.5 kHz
Amplitude resolution 16 bits (ADC)
Sensitivity range 10 – 150 kHz
Trigger modes Manual, Continuous,
Crest Adv, Crest, Period
Crest Adv X X
Frequency trigger (Crest) 4 parameters Crestfaktor / RMS / Peakwert / HochPass 6 / 2 / 2 / 6 X X
Frequency trigger (Crest Adv) 3 param. Crestfaktor / min. F / max. F 7 / 15 / 155 X X
Period trigger 2 parameters mnPer / sdPer 8 / 20 X X
Rec. duration after trigger (post-trigger) 0 – 53.5 sec @ 312.5 kHz SR 1 s X
Rec. duration before trigger (pre-trigger) 0 – 53.5 sec @ 312.5 kHz SR 0.5 s X
Rec. duration with manual trigger 0 – 53.5 sec @ 312.5 kHz SR 10 s X
Rec. duration with continuous trigger 0 – 53.5 sec @ 312.5 kHz SR 53.5 s X
Two time windows programmable per day for recordings (time of the day) None set X X
Recording in intervals in time windows with preset pause times (number of minutes) 0 = no int. X X
Additional measurements (Position, time, temperature)
Position GPS (coordinates / elev. meters .a.s.l / time)
GPS mode on / off on X X
Temperature reading Resolution 1°C (internal / plug-in mic.)
Microphone Electret microphone
Speaker
A
Piezo, 90dB
Audio output Headphone (3.5 mm mini jack/ 2 ch. mono)
Data storage
Storage media SD-, SDHC card (SD 2.0), max. 32 GB
FAT32 formatted
Length of single “calls” sequences 0 – 53.5 sec per file @ 312.5 kHz SR max 53.5s
Recording per GigaByte approx. 25 minutes (real time)
BATLOGGER Manual Elekon AG Nov. 2012 26/28
wählbar / einstellbar über Tasten
wählbar / einstellbar
über Parameterfile auf SD-Karte
Default-Werte