- 3 -
2.0 Description of equipment and overview
The MULTISPOT M80 resistance welding unit is designed for the
special requirements of motor vehicle body repair.
The power source is controlled by a micro-processor. After selecting the operating
mode and the sheet steel thickness, the current and weld time will be assigned
automatically and – where necessary and advisable – corrected accordingly. An
audible alarm is performed, if the welding current is too low.
Further functions:
– Automatic tool recognition
– Integrated mains monitor recognises undervoltage
– Automatic current rise, welding, current recognition and repressing
– Easy and distinct operation by means of foil keyboard
– Thermal probe controlled air-cooling for gun and tongs
– Central connection for welding current, compressed air, cooling and control
wiring
– Closed box for accessories in power supply unit
– Sturdy trolley with basin for tools and accessories and electrode arms
60 Tongs holder * * in connection with spot
61 Cable holder welding tongs
62 Trolley frame **special accessories (item no.
63 Central connection socket pls. see from accessories list)
64 Balancer **
65 Filter pressure reducer
66 Mains switch
67 Service box
68 Power supply unit
69 Screws 8 x 16
70 Screws 8 x 16
71 Trolley base
72 Roller
73 Guide wheel
74 Receptacle for pulling tool + SAH
75 Receptacle for electrode arms
76 Fastening screws
77 Electronics / operation panel
To Next Page
