14
Remote Control Setup
1. Open the cover.
2. Use A size batteries When inserting the batteries, make sure correct polarities + and -
marks
.two AA “” “”
.on the batteries line up correctly with compartment markings
3. Replace the battery cover.
To prevent battery leakage which may result in bodily injury or damage to the remote:
1. Install all batteries correctly, and as marked on the remote control.
2. Do not mix old and new batteries and o not mix alkaline, standard (carbon-zinc) or rechargeable
(ni-cad, ni-mh, etc.) Batteries
,
.
d
3 Remove batteries when the remote is not used for a long period of time..
REMOTE CONTROL
To Next Page
Loading...
