Element4 Sky - Page 56

56
Element4 Gas Fireplaces EuropeanHome.com
APPENDIX TWO
Transmitter batteries low.
Replace transmitter batteries. Quality
alkaline recommended.
Receiver batteries low.
Replace receiver batteries. Quality 1.5V AA
alkaline recommended.
Check that transmitter and receiver are
synchronized.
Reset system, see the installation manual
or the label on the receiver.
Transmitter distance is limited.
1. Straighten the antenna.
2. Replace the receiver.
FUNCTION POSSIBLE CAUSE REMEDY
Yes
2.
Magnet unit is energized
thus producing an obvious
latching sound.
No beep
3 short beeps
1 long beep
8-wire cable is o or
not operating
properly.
Conrm proper operation of the 8-wire
cable.
SW-cable
disconnected.
Conrm proper operation of the SW-
cable.
Motor not operating
properly.
Replace gas valve.
Micro switch not
operating properly.
Replace gas valve.
No
No
No
No
3.
Spark will occur
each second.
Ignition components not
operating properly.
Check connection between ignition cable
and ignition electrode.
Check ignition electrode spark gap.
Check ignition electrode.
Check ignition cable for damage.
Increase distance between ignition cable
and all metal parts.
Impulse magnet not
operating properly.
Replace gas valve.
Receiver batteries low.
Replace receiver batteries. Quality 1.5V
AA alkaline recommended.
No
Ignition sequence stops, no pilot
ame.
No reaction to transmitter
command.
Reset system.
Remove ground bolt and clean ground lug.
Do not coil the ignition cable.
Shorten the ignition cable, if possible.
No
Ignition sequence stops, no pilot ame.
Transmitter command is possible.
Replace receiver batteries. Quality 1.5V AA
alkaline recommended.
No
Yes
Yes
(continued)
1.
Press UP and OFF buttons
to start ignition sequence.
Beep will occur each
second.
START