WARNINGS AND PRECAUTIONS
ELITE ACTUATOR-1 REQUIRES POSITIVE STOPS TO BE INSTALLED ATOPENING AND CLOSING
POSITIONS OF THE GATE IN ORDER FOR THE GATE OPERATOR TO FUNCTION.
NOTFOR INSTALLATION ON SMALLAND LIGHTGATES OR ANY
GATE UNDER 4.5’ OR 1.5’ FRAME. INSTALLATION ON SUCH
GATES WILLCAUSE DAMAGE TO THE GATE AND POSTS.
NOT FOR INSTALLATION ON
ANY PEDESTRIAN GATES.
NOTFOR INSTALLATION ON ANY
PASSAGES OR DOORWAYS.
CAUTION: DO NOTINSTALLOPERATOR WITH ARM FULLY EXTENDED
OR OPERATOR WILLLOCK UP. USE THE “C” MEASUREMENT.
CAUTION: DO NOTBEND THE WIRE CONNECTION
FROM THE OPERATOR. TO DO SO WILLCAUSE
THE WIRES TO EVENTUALLY BREAK.
WARNING: TO REDUCE THE RISK OF INJURY TO PERSONS
THE ELITE ACTUATOR-1 IS FOR VEHICULAR GATE USE ONLY
BE SURE TO READ AND FOLLOW ALL THESE IMPORTANT INSTRUCTIONS BEFORE INSTAL-
LATION OF THE ELITE ACTUATOR-1. ELITE ACCESS SYSTEMS, INC. IS NOT RESPONSIBLE
FOR IMPROPER INSTALLATIONS OR FAILURE TO COMPLY WITH LOCAL BUILDING CODES.
DO NOT I N S TA L L UPSIDE DOWN, A S
WATER WILL GET IN VENT HOLES ON
BOTTOM OF OPERATOR AND DAMAGE IT
DO NOT INSTALL NEXT TO
SPRINKLERS OR ANY AREA
THAT MAY EXPOSE BOTTOM
VENTHOLES TO WATER.
WARNING:DO NOT LUBRICATE SHAFT. OIL
CAN GETINTO THE MOTOR AND DAMAGE IT.
To Next Page
Loading...
