CONDITIONS OF USE
Permitted use
For safety reasons the instrument must be installed and used according to the instruction provided and in parti-
cular, under normal conditions, parts bearing dangerous voltage levels must not be accessible. The device must be
adequately protected from water and dust as per the application and must also only be accessible via the use of
tools (with the exception of the frontlet).
The device is ideally suited for use on household appliances and/or similar refrigeration equipment and has been
tested with regard to the aspects concerning European reference standards on safety.
Unpermitted use
Any other use other than that permitted is de facto prohibited. It should be noted that the relay contacts provided
are of a practical type and therefore subject to fault. Any protection devices required by product standards or
dictated by common sense due to obvious safety reasons should be applied externally.
TECHNICAL DATA (EN 60730-2-9)
Use: control device (not safety) to integrate
Mounting: panel mounting with 71x29 mm (+0.2/-0.1 mm) drilling template
Control type: 1.B
Pollution rating: 2
Material class: IIIa
Overvoltage category class: II
Nominal impulsive voltage: 2500V
Temperature: Operating: –5 … +55 °C - Storage: –30 … +85 °C
Power Supply: 230Vac (+10% / -10%) 50/60 Hz
Consumption: 4,5W max
Digital Output (relays): please refer to the device label
Fire resistance class: D
Software class: A
NOTA: check the power supply specied on the instrument label; for relay, power supply capacities
and PTC probes, contact the Sales Ofce.
To Next Page
Loading...
Need help?
General
