What to do if the Elma Industrial Equipment filter capacity display requests a filter change after installing a new filter cartridge?
If the filter capacity display requests a filter change even after a new filter cartridge has been installed, it may be due to the IN and OUT connections. Check these connections and fix them if necessary.
What to do if there is a water leak at the connections of Elma Industrial Equipment?
If you notice a water leak at the connections, consider the following possibilities: * The connection may not be screwed up to the limit stopper - check the connection. * The seal may not be positioned correctly - check that the seal is correctly positioned. * The connection may be defective - replace the connection.
General| Model | ST |
|---|---|
| Application | Industrial cleaning |
| Dimensions (W x D x H) | Varies by model |
| Weight | Varies by model |
| Material | Stainless steel |
| Series | Elmasonic xtra ST |
| Tank Capacity | Varies by model |
| Heating Power | Varies by model |
| Ultrasonic Power | Varies by model |
| Timer | Yes |
| Power Supply | Varies by model |
To Next Page
