Elmo ST-1200 D - Replacing Power Fuse

Amplifier fu se
8 Th ere sta nd tw o fu se below th e trans-
f or m er. Th e left one is for a mp lifier
and right one for exc it er la mp. The
va lue of bo th fu ses is 3A (3.15A) .
Exc it er la mp fu se
. Replacing power fuse
When pilot lamp does n ot 1 ight and mot or
does n ot star t al though power so ur ce co rd
h as no ab n or mal co ndit io n, ch ec k power
so ur ce fuse .
When
rep l acing power fu se , power so ur ce
co rd sho uld be pu ll ed out without fai l.
100 - 240V Type 230 - 260V Type
F
or U.S. A. and Canad a
Power So ur ce Ca pac ity of Fuse
lOO -260V AC 3A (3.15A)
Never use any fuse other than
the s pe cified value.
For
Scandinavia countries
When re pl ac ing power fu se for
this m ode l,
1. Di sco nn ect the pow er cord.
2. Take off rear cover by loosing
screws of the cover a nd rep lace
power fu se whi ch is l ocate d on the
right side of transformer .
29