Elmo ST-1200 D - Electrical Settings; Voltage Selection; Frequency Selection

30
Voltage selection
.Th ere is a single vo ltag e mode I in co mp l i ance with el ectr ic regu l at ions or
conditions of eac h cou ntry.
o When se l ect ing voltage, power cord
should be pulled out with o ut fail.
o Tak e off the rear cover by taking out
two
set scre ws on the upp er side.
8 Pull the vol tage se l ect ion soc k et , adjust
the voltage to the power so ur ce to be
see n the volt age value for set ting from
th e notch and put it aga in.
Frequency selection
. Frequency is a lr eady set e ith er 50Hz 01' 60 Hz to correspo nd with the co untr y to be de-
li ve [·ed. Wh en frequ ency se l ect ion is requi red, it is recommendabl e to co nsult with the
n ea r est E lm o dealer. When it is done by yo ur se lf, h owever, do it as fo ll ows .
60Hz .... ----> . 50Hz
o P ul l o ut the power so u rce cor d.
o Take off the r ear cover by turning two
set screws co un tercloc kwi se .
8 As shown in the picture, change the
belt in accordance with the required
frequency.
No te: Ther e is a s i 'ng le fr equ ency model in
accordance wit h the e l ect ri c condi-
tio ns of eac h co untr y.