ELNA 344 - Connecting Machine to Power Supply; For Your Safety

14
Connecting Machine to Power Supply
For Your Safety
1. While the machine is in operation,
always keep your eye on the
sewing area and do not touch any
moving parts-needle(s),
flywheel, movable cutting blade,
loopers, etc.
NOTE:
Use the foot control that corresponds
to your voltage.
The power switch should be off.
= ON
= OFF
Before connecting the power cord/foot
control, make sure the voltage and
frequency shown on the machine are
identical to your electrical power.
Insert the machine/foot control plug
into the machine and the power
supply plug into the wall.
2. Always switch off the power switch
and unplug from the power supply:
when leaving the machine unattended
when attaching or removing parts
when cleaning the machine.
3. Do not place anything on the foot control.
ON
OFF
4C-326G (230v)
4C-326C (240v)
4C-316C (220v)
4C-316B (120v)