ELNA 745 - Page 55

56
TRIPLE COVER HEM
Select 10 and set up machine.
The Triple Cover Hem measures 5.0 mm in
width. It uses three needles and the chain
looper to form 3 lines of what looks like
parallel straight stitches.
Common Uses
• Hem finish.
• Topstitching.
• Belt loops.
Thread in the following sequence:
1
brown thread for chain looper (I)
2 blue thread for L0 needle (B1)
3 red thread for L1 needle (D1)
4 yellow thread for L2 needle (E)
NOTE: The needle threads should be
separated in the last two guides with the blue
to the far left, then red and finally yellow.
COVER HEM WIDE
Select 10 and set up machine.
A version of the cover hem that measures 5.0
mm in width. The garment industry commonly
uses this wider width on knitwear.
Common Uses
• Hem finish.
• Topstitching.
• Belt loops.
Thread in the following sequence:
1
brown thread for chain looper (I)
2 blue thread for L0 needle (B1)
3 yellow thread for L2 needle (E)
NOTE: The needle threads should be
separated in the last two guides with the blue
to the far left.