ELNA TX - Bobbin Placement and Lower Threading

Putting the
Bobbin in Place and
3 Continue
to hold back the bobbin.
By pulling the
Threading
the Lower Thread
thread and pressing it downwards
with the index
finger, It will snap into the
tension device.
There is no bobbin case,
The bobbin
Is placed direct In the rotary
hook, i.e.:
4 Immediately check
that the thread will not
1
Open the
rotary
hook
cover
by pushing
it to the
come
out of
the tension
device.
When
it is
back,
as
far
as it will
go.
Drop
the bobbin
into the
pulled
gently
upwards,
it should
not
come
rotary
hook,
holed
side
upwards.
out
of the
slit (2-a).
If by
chance
it
should
do
so,
repeat
the
operations
as
explained
2 Hold back the bobbin with the left index finger. under 2 and 3. Pull about 15 cm of thread
Slide
the
thread
into
the
slit
(a).
Bring
it
around
to
out
towards
the
rear.
the front, at the angle Illustrated (b).
15