ELNA TX - Upper Threading

Threading
the
Upper
Thread
Make
sure
that
the
thread
take-up
lever
and
the
foot
4
Thread
take-up
lever
-
pass
the
thread
through
are
in
their
highest
positions,
the
rear
of
the
notch
in
the
cover,
from
right
to
left,
passing
it
around
the
thread
take-up
lever.
The
1 Pull out the
spool pin and place the
spool of
thread will slip into
the opening of the thread
take-
thread
on
it.
Hold
back
the
spool
with
the
tip of
up
lever.
your
finger
and
pass
the
thread
through
in
the
following
order:
(all
the
thread
guides
are
open,
5
Thread
guide.
including
the thread
take-up
lever).
6
Needle
clamp.
Pull
the
thread
well
Into the
clamp.
2 Thread
guide.
(Ba)
The
thread
has
not been
pulled
well into
the
3
Universal
upper
thread
tension,
marked
between
needle
clamp.
4/2
and
5
.
(6b)
Correctly
threaded
needled
clamp.
7
Needle.
It is
threaded
from
the
front
to
the
back.
(If
tto
ensure
good
sewing
the
needle
threader
is used,
it must
therefore
be
Important
tinserted
Into
the
eye of
the needle
from
the
back).
results:
8
Pull forward
about
15 cm
(6")
of thread
to the
Give
the
thread
a
sharp
tug
upwards
so
that
it
is
front.
properly
engaged
in the
tension
device
(3).
Check:
If the thread
is then
pulled
downwards,
e ln
a
it should
not come
out of the tension
device.
17