ELNA TX - Darning

Darning
Use darning thread.
With a little practice,
you will find it easy
to darn by
3 Keep the
fingers as close to
the darning foot as
machine and thereby
make your household
linen,
possible and
finish the darn by sewing
parallel
undergarments,
working
clothes, etc. last two
to three
serpentines backwards
and forwards. To reinforce
times longer.
worn-out
spots, it is not necessary
to sew a
1
First
put
the
darning
plate
(a)
in
place
and
then
screen
first.
attach the darning
foot.
Threading Very Slippery
Threads
The darning plate
simplifies darning
without a
Certain very
slippery threads (usually
synthetic) can
darning hoop, since
it covers the openings
in the
tend to fall In spirals
from the spool onto
the machine.
needle
plate making Itunnecessaryto
haveaspecial
additional
mechanism for lowering
the feed dog. 4 To
avoid this, place the removable
spool pin on
the bobbin
winder stop, as well as
the spool.
The darning foot does not have
a removable
Raise the retractable spool
pin and pass the
sole. Unscrew the fixing screw and remove the thread through the hole (a). Next, thread in the
foot
support. Attach
the
darning foot
from the
usual
way.
rear. The lever of
the foot touches the
rear of
the
stud
(b) on
the
needle
clamp.
Threading
when
using
Twin
Needle
5
Place
the removable
spool
pin
on the
bobbin
Turn the stitch
width and length dials to the position winder stop, as well as the spool.
Place the
second spool
on the retractable
spool pin, after
having raised
It Hold the
2 threads
and thread
Don't
forget to lower the
presser foot before
them
together in the usual
way, up to the needle
starting
to darn and
hold back the
threads.
clamp
(see pages 16-17).
6
Next pass a thread
to one side and the other
to
2
Lower the needle into
the material. Stretch
the
the other side
of the needle clamp.
Thread the two
material tightly between the fingers and sew a eyes of the needle. Draw up the lower thread In
screen of closely woven stitches, moving from the usual way, but holding the 2 upper threads
right
to
left and
vice
versa.
(pages
18-19).
35