ELNA TX - Page 48

The material Is fed unevenly Pages The motor runs but the machine
does not Pages
-
Needle plate not
fitted properly
.......... 46-47
-
Tighten the flywheel
coupling knob
...... 12-13
/
-
Sewing foot not lowered
or not attached
securely
The
bobbin winder runs
but the machine does
not
- Sewing foot not suitable for
the kind of work 22-35 - Tighten the flywheel coupling knob . ..... 12-13
- Stitch length not suitable for job
- Stitch length (for superautomatic stitches) The stitch selector
cannot be turned
not set at "S" red .....................
29-31
- Feed dog needs cleaning .............. 46-47 - Stitch width dial should be set at",....
It
is
not
possible
to obtain
the
stitch
desired
The
front
protection
flap
cannot
be
closed
- Stitches in the green zone: stitch length dial - Thread take-up lever should be at its lowest
should
be set between 1/ and 4.
position
.............................
47
- Stitches in the red zone: stitch length dial
should be set at "S" red, in the
notch (click The protection flaps cannot be put beck Into place
stop).
- Put them back according to the red marks.
4-5
The needle breaks The left protection flap cannot
be put beck into place
- Foot,
needle plate and darning plate not - Not fitted properly, the red dot should
be on
fitted properly ................... 8, 34 and 46 the outside ..........................
4-5
- By pulling the material, the needle strikes
the foot or the needle plate The machine
will not run
- Needle too fine for the material and the
thread
..............................
40
-
Check
power
supply
-
Needle
not
of the
system
130/705
H
(15 X 1),
- Switch
on
the
safety
switch
.............
10-11
of
poor
quality,
bent,
not
inserted
properly,
-
Darning
foot
not
fitted
corrrectly
.........
34-35
not suitable for the kind of
work ....... 9 and 40
-
Upper
tension
too tight
.....
.........
41
-
Remains
of thread
or lint
in
the
rotary
hook:
a Remove needle, bobbin and needle plate
The machine runs too slowly
* Turn the flywheel slightly by hand, several
- Tighten
the
flywheel
coupling
knob
......
12-13
times,
first
backwards,
then forwards,
until
-
Disconnect
and
reconnect
the
foot control.
11
the
thread tangle
has
been cuL
Clean
out
Check
that
the slide
of the
speed
controller
the remains
of thread
.....
...
46-47
is
at the
top
..........................
11
*
Oil
the
rotary
hook
and
run
the
machine
n
a
-
Put
a
drop
of
oil
in
the
rotary
hook
......
12-13
without
thread
for
a
few
seconds
......
13
The
machine
Is noisy
The
buttonhole
is not sewn
correctly
-
Rotary hook has
not been oiled
or is dirty .
12-13
- Wrong foot
and stitch length
too short ....
32-33
- Needle is blunt
A-I
0.86-
Anglais
-
N
0
103
382-1
t
Tavaro
$A.,
Genbve
-
Suiss