Elo Touch Solutions SE2707 - Setting to Default Parameters

User Manual – 2D Barcode Scanner (Zebra)
UM600xxx Draft, page 18 of 40
Setting to Default Parameters
Scan one of the following bar codes to reset the engine to its default settings as follows:
Restore Defaults resets all default parameters as follows:
• If you configured custom default parameter values via the Write to Custom Defaults bar code, scanning the Restore
Defaults bar code restores these custom values.
• If you did not configure custom default parameter values, scanning the Restore Defaults bar code restores the factory
default values.
Set Factory Defaults clears all custom default values and sets the factory default values.