User Manual – 2D Barcode Scanner (Zebra)
UM600xxx Draft, page 19 of 40
USB Interface Parameters:
Reader Interface
Scan one of the following barcodes to select the USB device type. To select a country keyboard type for the USB Keyboard
HID host, see USB Country Keyboard Types - Country Codes.
NOTES:
• When changing USB Device Types, the decoder resets and issues the standard startup beep sequences.
• When USB HID Keyboard Emulation or USB CDC Host is selected, and the Trigger Mode is set to Host, the decoder
is in locked mode and no scanning is possible. The decoder exits this mode if the host sends the following commands
to the decoder. The decoder’s trigger mode can then be changed by the host.
• For HID Keyboard Emulation send switch to SNAPI host command. Use the Zebra SDK C Sharp Sample
Application or 123Scan to do this.
This is the default setting for the scanner out of the box.
To Next Page
Loading...
Need help?
General