Elpress V1311C - Tooling for Al-Terminals; Al-terminals

Al-terminals (only for crimptool V1311)
When crimping Al-terminals of Elpress design the tools below should be used. To choose the correct matrix and
punch, see tooling table below.
1. Matrixholder V1320 (not necessary when crimping 185 and 240 mm
2
).
2. Matrix (encloses the Al-sleeve and thereby avoiding deformation when crimped).
3. Punch (to be crimped down to a stop position, i.e. at a point where the bottom side of the
punch fl ange halts against the matrix surface).
IMPORTANT! Two compressions are required when crimping Al-terminals. Crimping sequence as per
fi gure below.
The correct location of the two compressions is determined by the matrix grooves being
locked by a spring-loaded ball in the fork. It is important to check for proper location.
14
Tooling table for indent crimping of Al-terminals
Stranded Solid Matrix Punch
mm
2
mm
2
16 16(+25) P13M P13D
25 35 P13M P13D
35 50 P20M P20D
50 70 P20M P20D
70 95 P20M P20D
95 120 P25M P25D
120 150 P25M P25D
150 185 P25M P25D
185 240 13P32M* P32D
240 - 13P32M* P32D
* Matrix with the prefi x 13-- are used without matrixholder.
1
2
3
New crimping sequence for
aluminium.