1 Parameterizing with GW-GNET+
gas-net F1
Page 1-6
1.3 Extras: GW-GNET+ Service Programs
The GW-GNET+ program includes some additional service programs fulfilling
different tasks relating to gas-net devices. The range of available service
programs depends on the gas-net device type.
For instance, the following tools are available for flow computers:
Edit parameterization for changing the parameterization during an
established data connection to the device.
Purely operational parts of the parameterization
can be changed this way, even though the
calibration switch is closed.
Note: For instructions, please refer to the GW-
GNET+ online help.
Change parameters for changing individual parameters during an
established data connection to the device.
Note: For instructions, please refer to the GW-
GNET+ online help.
Totalizer setting Facilitates the setting of totalizers of the gas-net
device if the calibration switch is open.
Delete archives Facilitates the deletion of archives of the gas-net
device if the calibration switch is open.
DSfG bus access Starts GW-REMOTE+ via the data interface, if
installed. Facilitates the data access to all
devices connected via DSfG; for instance, for
reading out archive data and viewing current
data.
In particular, GW-REMOTE+ provides a com-
fortable freeze function.
These programs may only be activated if a data connection is established via
the DSS data interface.
To Next Page
Loading...
Need help?
General
