2 Installation
gas-net F1
Page 2-10
The length of the antenna cable to be ordered depends on the distance
between modem and antenna.
Commissioning of Wireless Modem
Have the PIN number at hand, if required.
After having installed the antenna, connect it to the modem using the
antenna cable. The antenna must be aligned to the maximum receiving
level, except for the case that the antenna is an omnidirectional one.
Note: The further commissioning of the integrated RDT with wireless modem
is described in Chapter
3.3 from page 3-7.
It is especially important for the further proceeding to enter the correct PIN
number of the SIM card in the parameterization data record of the gas-net
device.
Please also observe the following notes on the correct voltage connection of
a Siemens M20 or TC35 wireless modem:
To Next Page
Loading...
Need help?
General
