Eltek FlatpackS 48/1000 HE - Terminals and Pin-Out Locations, Smartpack S Controller; Location of Connector, Communication Ports

Erro! Use a guia Página Inicial para aplicar Heading 1 ao texto que deverá
aparecer aqui. Erro! Use a guia Página Inicial para aplicar Heading 1 ao texto
que deverá aparecer aqui.
10 User’s Guide Flatpack2 Rectifier & Supervision Modules,
Terminals and Pin-out Locations, Smartpack S
Controller
Location of Connector, Communication Ports
For a complete list of signals, pin-out, etc, refer to chapter “Connection Drawing” on
page12
Location of pluggable terminal blocks, RS232/RS485 port and Ethernet connector in
the Smartpack S controller (the pluggable terminals may be black or green)
All the controller’s system connections to the system’s backplane are implemented via an
edge connector, when inserting the controller in the power system.
Notice that when using the RS232 / RS485 port, you must configure RS232 to COM1 and
RS485 to COM2, e.g. via PowerSuite.